GD V2 – Part 15

March 27, 2016


Built up the bottom end with Wossner oversized pistons (86.5mm), Apex Performance rods and ACL race bearings. I checked the gap on all the pistons rings and they were all within spec out of the box which was a nice surprise. One wrist pin was tight on a small end bearing on the Apex rods, but only on one edge which was odd. The problem was in the rod so I decided to just file this edge away slightly to free up movement of the pin; the rest of the bearing was unaffected and had a good fit.

It was a relatively straight forward job putting the pistons in.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: