GD V2 – Part 13

March 12, 2016


A few important parts have arrived which means I could continue with the rebuild. I cleaned up the crank and replaced the chain sprocket with a new one. There was quite a bit of wear on the old one as can be seem in the photo; the tooth thickness is noticeably smaller than on the new one.

I then reassembled the crank into the block with new ACL Race main bearings and Lucas Oil Assembly Lube, and then torqued everything up.

I’m still waiting for the oversized pistons to arrive so I decided to carry on with what I could.

New chain, tensioner and guide were installed and set, then replaced the cover with the oil pump with a new crank seal. I checked and cleaned the oil pump and it was in great condition so didn’t change anything there.

I decided to install the water pump as well just so I could see the new light weight Aluminium pulleys.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: